Klipsch Synergy Black Label C-200 Center Channel Speaker User Manual

Table of Contents

1. Introduction
2. Package Contents
3. Speaker Placement
4. Connecting the Speaker to an AV Receiver or Amplifier
5. Troubleshooting Tips
6. FAQs

1. Introduction

Welcome to the world of Klipsch Synergy Black Label C-200 Center Channel Speaker! This high-performance speaker is designed to deliver crystal-clear dialogue and vocals, providing you with an exceptional home theater experience. With proprietary horn technology, dual 5.25" high-output woofers, and a dynamic 1" tweeter, the C-200 ensures that every bit of dialogue is captured with precision.

2. Package Contents

• (1) C-200 Center Channel speaker with power cord
• User Manual

Note: External wiring is not included.

3. Speaker Placement

Place the C-200 Center Channel speaker directly below or above your TV, ideally at ear level when seated in your primary listening position. The speaker should be horizontally aligned with the front left and right speakers to ensure a seamless soundstage.

4. Connecting the Speaker to an AV Receiver or Amplifier

1. Ensure that your AV receiver or amplifier is turned off and unplugged from the power source.
2. Locate the speaker terminals on the back of the C-200 Center Channel speaker. You will see two terminals: one red (+) and one black (-).
3. Prepare your speaker wire by stripping the insulation from both ends, revealing approximately 1/2 inch of bare wire.
4. Insert the bare end of the speaker wire into the appropriate terminal on the back of the C-200 speaker. Connect the positive (+) terminal on the speaker to the positive (+) terminal on your AV receiver or amplifier, and the negative (-) terminal on the speaker to the negative (-) terminal on your AV receiver or amplifier.
5. Secure the speaker wire connections by tightening the terminal screws.
6. Plug in and turn on your AV receiver or amplifier, and configure the settings according to your system requirements.

5. Troubleshooting Tips

1. If you experience no sound or low volume, ensure that your AV receiver or amplifier is turned on and properly connected to the C-200 Center Channel speaker.
2. Verify that the speaker wire connections are secure and correctly connected to the appropriate terminals.
3. Check your AV receiver or amplifier settings to ensure the center channel speaker is enabled and configured correctly.
4. If you experience distortion or poor sound quality, try adjusting the volume, tone, or balance settings on your AV receiver or amplifier.

6. FAQs

Q: What type of speaker wire should I use to connect the C-200 Center Channel speaker?

A: We recommend using high-quality speaker wire with a gauge of 16 or lower for optimal performance.

Q: Can I use the C-200 Center Channel speaker without an AV receiver or amplifier?

A: No, the C-200 Center Channel speaker requires an AV receiver or amplifier to provide audio signal and power.

Q: How much power does the C-200 Center Channel speaker require?

A: Ensure that your AV receiver or amplifier is capable of supplying sufficient power to the speaker for quality audio reproduction and longevity of the speaker's components.

Q: Can I use the C-200 Center Channel speaker for surround sound systems?

A: Yes, the C-200 Center Channel speaker is designed for use in surround sound systems and can be combined with other Klipsch Synergy Black Label speakers for an immersive home theater experience.

Q: How do I clean and maintain the C-200 Center Channel speaker?

A: Use a soft, dry cloth to gently clean the speaker's surface. Avoid using harsh chemicals or abrasive materials that may damage the speaker's finish.

Q: What is the recommended wattage amplifier for the Klipsch Synergy Black Label C-200 Center Channel Speaker?
A: The C-200 has a 100 Watt continuous power rating at 8 Ohms nominal with a 400 Watt peak. We recommend at least 80 Watts per channel at 8 Ohms and not going over half way to the peak power on our speakers, so the maximum recommended would be 200 Watts per channel at 8 Ohms.

Q: Is this speaker magnetic shielded?
A: Magnetic shielding is typically not necessary as the magnets mainly affected older CRT TVs, but this design still has shielded drivers anyway (Low Frequency Drivers Dual 5.25” (13.3cm), magnetically shielded IMG woofers.).

Q: Does this speaker come with a mesh cover or grill?
A: Yes, this speaker does come with a mesh cover or grill.

Q: What is the frequency response and crossover frequency of this speaker?
A: The C-200 frequency response is 82Hz-23KHz ± 3dB.

Q: Can I use this speaker in a car?
A: The C-200 is designed for home theater and requires a receiver for audio signal and power. It can be used wherever you can connect the wires, but it's not a very practical speaker for a car.

Q: Is there an "Aux" input jack on this speaker?
A: No, there isn't an "Aux" input jack on this speaker. The C-200 is a passive speaker that requires a speaker wire connection to an AV receiver for audio signal and power.

Q: What's the difference between the "Black Label" and normal Klipsch speakers?
A: From what we can tell, it's mainly the cosmetics that make it different. It has a less expensive finish than real wood veneer, but we have found the sound quality to be superior. The Klipsch Synergy Black Label series also features proprietary Tractrix horn technology, which provides a uniform, 90 x 90 dispersion pattern and allows for placement just about anywhere.

Q: What's included in the box?
A: The box includes (1) C-200 Center Channel speaker with a power cord. External wiring is not included.

Q: Is this speaker Bluetooth-enabled?
A: No, the C-200 is a passive speaker that requires a receiver for audio signal and power. Bluetooth capability would be an option to look for in the receiver you use with this speaker.

Q: Would the Klipsch C-200 work with a Marantz NR 1510 AV system and the Klipsch RP-400M that I have, or is there a better recommendation for a center speaker?
A: The RP-400M is fine with that receiver, and the best match to the RP-400M for center channel is RP-400C, which would work well with it too. The C-200 has a 100 Watt continuous power rating at 8 Ohms nominal with a 400 Watt peak. We recommend at least 80 Watts per channel at 8 Ohms for this model.

Q: What are some customer reviews of this product?
A: Customers have reported that the Klipsch Synergy Black Label C-200 Center Channel Speaker provides crystal-clear dialogue and vocals, accurate and non-fatiguing sound, and creates an amazing soundstage with its latest technology. Customers have also praised its contemporary finish that integrates easily with any decor.